LM-KM485 marker strip 8.5 mm × 25 m – terminal block marking (MAX)

LM-KM485 is a white marker strip (MAX "marking plate"), 8.5 mm wide, 0.5 mm thick, on a 25 m roll. It is printed with numbers and symbols per pitch, cut and clipped into the marker slots of terminal blocks to identify each terminal.

According to the MAX manual, the LM-3000PRO desktop printer prints marker strips with a print height of about 6.9 mm, pitch 2.5 – 99 mm and up to 5 m per job (10 m for multiple copies); half-cutting is not available for marker strips. The roll sits on the supplied reel stand with flanges.

Choose the width to match your terminal block marker slot; the range also includes LM-KM495, LM-KM410. Advice: +84 0917 399 279.

Product videos

MAX marker strips at TOVINA

• LM-KM485 — 8.5 mm wide, 0.5 mm thick, 25 m
• LM-KM495 — 9.5 mm wide, 0.5 mm thick, 25 m
• LM-KM410 — 10 mm wide, 0.5 mm thick, 25 m

Printing on the LM-3000PRO

• Place the roll on the reel stand with flanges and feed it through the guide.
• In LETATWIN PC EDITOR PRO select MAX marking plate and the width; use table mode for group headers.
• Set the pitch to the terminal spacing (2.5 – 99 mm); separator: line, dots or none.
• Marker strip loading video below; general guide: User guide.

FAQ

• Which printer does LM-KM485 fit? MAX lists marker strips for the LM-3000PRO; LM-550 printers use ID plates and tape instead.
• Can it be half-cut? No – marker strips are cut by pitch without half-cutting.